Seite - 1584 - in Book of Full Papers - Symposium Hydro Engineering
Bild der Seite - 1584 -
Text der Seite - 1584 -
equation for velocity. This equation in the global model is used to calculate a
particle's new velocity according to its previous velocity and the distance of its
current position from its own best experience (pbest) and the group's best
experience (gbest). The local model calculation is identical, except that the
neighborhood’s best experience is used instead of the group's best experience.
The constants 1c and 2c in above equation represent the weighting of the
stochastic acceleration terms that pull each particle toward pbest and gbest
positions. Thus, adjustment of these constants changes the amount of ‘tension’ in
the system. Low values allow particles to roam far from target regions before tugged
back, while high values result in abrupt movement toward, or past, target regions.
The inertia weight w controls the impact of the previous histories of velocities
on the current velocity, thus influencing the trade-off between global (wide-ranging)
and local (nearby) exploration abilities of the ‘flying points’. By linearly decreasing
the inertia weight from a relatively large value to a small value through the course
of the PSO run (total number of generations prior termination), the PSO tends to
have more global search ability at the beginning of the run while having more local
search ability near the end of the run [10].
3. RESULTS
In order to evaluate the effects of dam height (H) and width of the foundation (W)
on the finite element solution, some experiments had been carried out in the finite
element model [9] (See Table 2). On the basis of experiments, it had been found
that lateral extent must be selected less than twice the dam height in the finite
element model. In this work an energy fitness function has been defined so that
horizontal displacement time history at the dam crest in the finite element model
on the earthquake response be minimized. The fitness function has been
considered as a function of B/H ratio and we minimize the cost function using PSO
algorithm.
In this experiment, the following PSO parameters are used:
Population size: 30; Weightmax=1; Weightmin=0.4; C1 =C2 =2; Dimension=2;
Iteration: 1000. B and H parameters change between 50-200 and 30-90,
respectively. The PSO algorithm were implemented using MATLAB from Math
Works. In this experiment, by using the PSO algorithm the B/H ratio should be
equal to 1.29.
1584
Book of Full Papers
Symposium Hydro Engineering
- Titel
- Book of Full Papers
- Untertitel
- Symposium Hydro Engineering
- Autor
- Gerald Zenz
- Verlag
- Verlag der Technischen Universität Graz
- Ort
- Graz
- Datum
- 2018
- Sprache
- englisch
- Lizenz
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Abmessungen
- 20.9 x 29.6 cm
- Seiten
- 2724
- Schlagwörter
- Hydro, Engineering, Climate Changes
- Kategorien
- International
- Naturwissenschaften Physik
- Technik