Seite - 1644 - in Book of Full Papers - Symposium Hydro Engineering
Bild der Seite - 1644 -
Text der Seite - 1644 -
Fig. 4
Defined erosion paths within the embankment dam section
The continuation of erosion shall be assessed by mean hydraulic gradients
derived from the seepage analysis. The definitions of the hydraulic head
difference and the flow path length are shown in Fig. 5.
The determined hydraulic gradients are given in Table 5. The critical
gradient for the present sand-gravels should be approx. ic = 0.20 to 0.40. For
finer sands this can decrease to ic = 0.15 and for silts to ic = 0.10 or even less.
For the dam body erosion path the material shows the firstly mentioned
gradients. However, the gradients within the dam body (Table 5) are generally
small i < 0.20, except for load case LCA3 where it reaches a value of i = 0.30.
Thus, for reaching the crest water level also backward erosion may continue
since hydraulic forces are strong enough. For the other load cases the erosion
through the dam body should not be a problem due to low gradients.
Fig. 5
Determination of the Hydraulic Head difference and Flow Path length using the
Total Head results of the Seepage Analysis (here: LCP1, OS - GC)
For the crest water level (LCA3) the hydraulic gradients are strong enough
to continue the erosion process through the dam body. This is a result of the
seepage control design which does not meet the requirements to European
codes and guidelines, especially German design philosophy. Processes within
the underground are also considered to be not critical thanks to the protective
clay layer and the conservative dam design.
Line ofSeepage (LCA3)
DB EP
UG EP 1/2 UG EP 2
UG EP 1
DB EP – Dam bodyerosionpath
UG EP 1 –Untergrounderosionpath1
UG EP 2 –Untergrounderosionpath2
E
D
A1
A2 A3
A4 A5
B1
B2
B4
C1
C2
C3 C4
C5
C6
C7
B3
B5
B6
Length of path for UG EP 1
Length of path for UG EP 2
Length of path for
DB EP
1644
Book of Full Papers
Symposium Hydro Engineering
- Titel
- Book of Full Papers
- Untertitel
- Symposium Hydro Engineering
- Autor
- Gerald Zenz
- Verlag
- Verlag der Technischen Universität Graz
- Ort
- Graz
- Datum
- 2018
- Sprache
- englisch
- Lizenz
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Abmessungen
- 20.9 x 29.6 cm
- Seiten
- 2724
- Schlagwörter
- Hydro, Engineering, Climate Changes
- Kategorien
- International
- Naturwissenschaften Physik
- Technik