Seite - 1711 - in Book of Full Papers - Symposium Hydro Engineering
Bild der Seite - 1711 -
Text der Seite - 1711 -
Table 4 shows the results of dam core layer remediation by low-pressure
permeation grouting for the dams in this study. Both dams that exhibited distinct
dam incidents during operation were remediated over the entire crest length of the
dams. The grouting depth reached to the bottom of the foundation rock mass.
The majority of the grout material was MC; however, OPC was also used in
WM dam, which had sinkholes and granular cores. To stabilize the grout holes and
mitigate bleeding during remedial grouting, up to 5% bentonite was added to the
mix, and this addition was found to be effective.
The average amount of cement used per meter (kg/m) was 39–40 kg/m for
AG and WM dams, which showed distinct incidents. The average grouting quantity
was varied from 18–24 l/min for WM and AG dams.
Table 4
Results of dam core remediation by permeation grouting
Dam WM AG
Total grout length (m) 16,932 11,131
Total grout quantity (m3) 1,544 825
Total cement quantity
(kg) 690,493
OPC: 94,170
MC: 596,323
Bentonite: 30,718 437,362
MC: 424,139
Bentonite: 13,223
Avg. grout quantity (l/m) 91.2 74.2
Avg. flow quantity (l/min) 23.9 18.2
Avg. cement quantity
(kg/m) 40 39
Avg. cement quantity
(kg/min) 11 9.7
Mixer RPM (min) 800 1,600
Remarks Total length of dam remediated;
two grouting rows;
mainly MC, partially OPC, and
bentonite 5% added for core
grouting,
no bentonite for rock foundation Total length of dam remediated;
two or three grouting rows;
MC used,
bentonite 5% added for core grouting,
no bentonite for rock foundation
4. VALIDATION
Because the remedial grouting state is not visible underground, the
remediation work is not easily validated quantitatively. However, a limited
validation can be attained by visual inspection of the surface, checkhole drilling
and sampling, analysis of the sampled core’s reaction to chemical indicator spray,
in-situ permeability testing, analyses of grout quantities and total seepage rate
change at the dam toe, and electrical resistivity surveys.
1711
Book of Full Papers
Symposium Hydro Engineering
- Titel
- Book of Full Papers
- Untertitel
- Symposium Hydro Engineering
- Autor
- Gerald Zenz
- Verlag
- Verlag der Technischen Universität Graz
- Ort
- Graz
- Datum
- 2018
- Sprache
- englisch
- Lizenz
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Abmessungen
- 20.9 x 29.6 cm
- Seiten
- 2724
- Schlagwörter
- Hydro, Engineering, Climate Changes
- Kategorien
- International
- Naturwissenschaften Physik
- Technik