Seite - 1911 - in Book of Full Papers - Symposium Hydro Engineering
Bild der Seite - 1911 -
Text der Seite - 1911 -
Fig. 4. Ultrasound equipment to test BGM welds
3. SOME CASE STUDY OF BGM IN HYDRAULIC CONSTRUCTION
In the cases mentioned here-under, all being in altitude (between 1.200 m
and 4.800 m), BGM was chosen for one or some of the following reasons:
High resistance to U.V.
High resistance to puncturing (geotextile inside geomembrane) so, avoiding
protection by geotextile underneath and above. In altitude as you have high
speed wind with BGM there are only 1 geosynthetic to install at the place of
3 for thinner geomembrane.
Highest unit mass means that you can install by wind more than 50 km/hour,
with humidity therefore under some rain. Like this you can shorten
significantly delays.
Low cost of installation by local workforces as the manufacturer assumes the
training of the installation personnel and you don’t need special equipment
for welding: only torch and bottles of propane gas.
3.1. In South America
3.1.1. Peru, Milpo tailings dam: a 30-m high earth and rock fill tailings dam
in Cerro Lindo (See Fig. 5) to store polluted water.
Milpo is a Peruvian mining company headquartered in Lima.
At the Cerro Lindo mine, a 30-m high, earth and rockfill dam was built to store and
control process water. The dam was built on a competent substratum reached
through shallow excavations in natural soil. It is located at an altitude of
approximately 2.000 m. in a region characterized by strong winds. This upstream
face of the dam was waterproofed by means of a BGM. The upstream portion of
the dam was built with compacted soil consisting of gravelly clay with a 1V/2H face
slope. In the middle of the dam, a transition layer of 2 m wide and runs from the
bottom to the crest of the dam. At the downstream toe, an infiltration-water
collection box and monitoring wells were installed to allow a permanent control of
watertightness.
1911
Book of Full Papers
Symposium Hydro Engineering
- Titel
- Book of Full Papers
- Untertitel
- Symposium Hydro Engineering
- Autor
- Gerald Zenz
- Verlag
- Verlag der Technischen Universität Graz
- Ort
- Graz
- Datum
- 2018
- Sprache
- englisch
- Lizenz
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Abmessungen
- 20.9 x 29.6 cm
- Seiten
- 2724
- Schlagwörter
- Hydro, Engineering, Climate Changes
- Kategorien
- International
- Naturwissenschaften Physik
- Technik