Seite - 1938 - in Book of Full Papers - Symposium Hydro Engineering
Bild der Seite - 1938 -
Text der Seite - 1938 -
Activity of a fault was initially taken as “activated” if at least once in the past
10,000 years. An active seismic source is now defined as a fault that has ruptured
within the last 35,000 years. However, this or any fault activity criterion is somewhat
arbitrary by its very nature. There is no physical reason why a fault that has not
moved during the last 35,000 years cannot move again. Case in point is the
October 16, 1999 Magnitude 7.1 Hector Mine Earthquake.
Allen and Cluff (2000) note the following:
1. There is no standard definition of what constitutes an "active" fault, which
reflects the geologic reality that all degrees of fault activity do, in fact, exist.
Any distinction between active and inactive faults is necessarily arbitrary.
2. In worldwide practice, faults in dam foundations that are estimated to have
ruptured on the average of once in every few thousand, or every few tens
of thousands of years, have typically been considered worthy of
engineering consideration.
3. At least some engineers appear to be gaining confidence that, with
innovative new techniques, dams of virtually all types can be designed to
accommodate moderate foundation fault displacements without major
failure.
4. Owing to advances in the ability to obtain absolute ages on geologic
materials, mainly through new geochemical techniques, degrees of fault
activities can now be estimated far better than only a few years ago. A
critical parameter in both probabilistic and deterministic assessments is
long-term fault slip rate.
5. Field studies of faults in dam foundations demand the expertise of
geologists trained and experienced in neotectonic studies. Classical
geological maps, however competently done, often have only limited
relevance to earthquake hazard assessments.
6. Seldom are adequate field exposures available in the dam footprint area
itself to characterize fully the neotectonic environment of a proposed dam.
It is virtually always necessary to carry out such studies, including trenching
of suspect faults, throughout a much wider area than that of the dam
footprint—typically extending over many tens of kilometers.
7. Seismologic studies of earthquakes in dam areas can play an important
role in safety evaluations, particularly in establishing seismic shaking
parameters such as maximum ground accelerations and velocities to be
expected. But field geologic efforts are nevertheless critical in estimating
the likelihood of surface fault rupture through a dam foundation. The
abundance or absence of microearthquakes may have little relevance to
the probability of large local earthquake associated with surface fault
rupture.
.
S. Gangopadhyay (1993) also noted that many of the dam sites in India had
various geological defects creating problems for the construction of the dam.
Precise evaluation of these weaknesses of dam foundations at the investigation
stage by engineering geological studies had helped cost-effective design and safe
construction of the structures after adopting suitable corrective measures.
1938
Book of Full Papers
Symposium Hydro Engineering
- Titel
- Book of Full Papers
- Untertitel
- Symposium Hydro Engineering
- Autor
- Gerald Zenz
- Verlag
- Verlag der Technischen Universität Graz
- Ort
- Graz
- Datum
- 2018
- Sprache
- englisch
- Lizenz
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Abmessungen
- 20.9 x 29.6 cm
- Seiten
- 2724
- Schlagwörter
- Hydro, Engineering, Climate Changes
- Kategorien
- International
- Naturwissenschaften Physik
- Technik