Seite - 1946 - in Book of Full Papers - Symposium Hydro Engineering
Bild der Seite - 1946 -
Text der Seite - 1946 -
Fig. 2
Main failure modes of dykes: 1 = Overflowing, overtopping â Erosion failure,
2 = Seepage through dyke â Internal erosion, 3 = Underseepage â Internal
erosion, Upheave, Ground failure
Principaux modes de dĂ©faillance des digues: 1 = Deversement sur le barrage â
Erosion, 2 = Infiltration Ă travers la barrage â Erosion interne, 3 = Infiltration ci-
dessous barrage â Erosion interne, Sous-Pression, Rupture ou sol
Due to this unpredictable behaviour hydraulic failure is frequently
underestimated in practice and may occur in different forms (e.g. Eurocode 7;
CEN 2004):
âą By uplift (buoyancy). The pore-water pressure under the low-permeability
blanket exceeds the overburden pressure.
âą By heave. Upward seepage forces act against the weight of the soil,
reducing the vertical effective stress to zero; soil particles are then lifted away by
the vertical water flow. This âboilingâ dominates in silty-sandy soil, and is
combined with internal erosion.
âą By internal erosion. Soil particles are transported within a soil stratum or
at the interface of soil strata. This may finally result in regressive erosion, leading
to ground failure of the dyke, levee or dam.
âą By piping. Failure by piping is a particular form of internal erosion, where
erosion begins at the surface, and then regresses until a pipe-shaped discharge
tunnel is formed. Failure occurs as soon as the water-side end of the eroded
tunnel reaches the river bed or bottom of the reservoir. Frequently, several
tunnels develop. This process may be induced or significantly promoted by
animal activities, as field observations over many years have revealed.
Hydraulic failure may occur despite cut-off walls. If they are âimperfectâ (i.e.
with underseepage), groundwater communication below the dykes or levees (for
environmental reasons) occurs and overpressure can develop beneath the
landside blanket and the safety against a failure of the subsoil reduces
significantly. The loss of stability is usually initiated by uncontrolled hydraulic
rupture (uplift) of the blanket or by concentrated transport of fine particles
(erosion, suffusion, piping) from the subgrade.
Hydraulic failure may reach several tens of meters away from dykes or
dams, as experience has shown (Fig. 3). This could be observed even for low
flood protection embankments with a relatively small hydraulic gradient. Soil
boiling may create large volcanos (e.g. Fig. 4) that require urgent flood defense
and stabilizing measures. 3
2
1
1946
Book of Full Papers
Symposium Hydro Engineering
- Titel
- Book of Full Papers
- Untertitel
- Symposium Hydro Engineering
- Autor
- Gerald Zenz
- Verlag
- Verlag der Technischen UniversitÀt Graz
- Ort
- Graz
- Datum
- 2018
- Sprache
- englisch
- Lizenz
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Abmessungen
- 20.9 x 29.6 cm
- Seiten
- 2724
- Schlagwörter
- Hydro, Engineering, Climate Changes
- Kategorien
- International
- Naturwissenschaften Physik
- Technik