Seite - 2060 - in Book of Full Papers - Symposium Hydro Engineering
Bild der Seite - 2060 -
Text der Seite - 2060 -
Furthermore, water velocity in module is around 1.1 m/s in the penstock inlet
section, and almost 2.5 m/s just 2 meters upstream the same section, values
equals and higher than the maximum recommended in literature (1 m/s).
2.4. THREE-DIMENSIONAL NUMERICAL MODELING WITH ANSYS
Among the different models of turbulence that complements the RANS
equations, ANSYS CFX is widely applied in the solution of many flows of
engineering interest. This software allows to use two-equation turbulence models
based in k-ε and in k-ω. In order to have a better knowledge of the numerical
results, the k-ε model has been selected in the two CFD codes, so that results can
be compared. This model is implemented in most general purpose CFD codes and
is considered the industry standard model. The effective viscosity is calculated as:
𝜇 = 𝐶
𝜇 𝜌 𝑘 2/𝜀 (4)
where 𝐶
𝜇 = 0.09 is an empirical coefficient, 𝑘 the turbulent kinetic energy and
𝜀 the dissipation rate of turbulent kinetic energy. The 𝑘 and 𝜀 values can be
obtained from the following equations:
(5)
(6)
𝐶
1𝜀 , 𝐶
2𝜀 , 𝜎
𝑘 and 𝜎
𝜀 are constants (1.44, 1.92, 1.0 y 1.3, respectively), 𝑃
𝑘 is
the turbulence produced by viscous forces, while 𝑃
𝑘 𝑏 and 𝑃
𝜀 𝑏 represent the
influence of the gravity forces. In ANSYS CFX and both phases, air and water, can
be solved through an homogeneous model. Actually, in order to compare with IBER
model, only the water phase has been solved. Meshes have been compounded
with hexahedral elements with a length scale of around 50 cm. Boundary
conditions and initial conditions are the same adopted for the 2D analysis in IBER..
Finally, in the results are observed two big recirculation areas of turbulence, just
near the penstock inlet, affecting the submergence safety conditions. Furthermore,
water velocity in module is around 1.5 m/s in the penstock inlet section, and almost
1.3 m/s just 2 meters upstream the same section, values equals and higher than
the maximum recommended in literature (1 m/s) and quite similar to the results of
IBER 2D modeling.
2060
Book of Full Papers
Symposium Hydro Engineering
- Titel
- Book of Full Papers
- Untertitel
- Symposium Hydro Engineering
- Autor
- Gerald Zenz
- Verlag
- Verlag der Technischen Universität Graz
- Ort
- Graz
- Datum
- 2018
- Sprache
- englisch
- Lizenz
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Abmessungen
- 20.9 x 29.6 cm
- Seiten
- 2724
- Schlagwörter
- Hydro, Engineering, Climate Changes
- Kategorien
- International
- Naturwissenschaften Physik
- Technik