Seite - 2096 - in Book of Full Papers - Symposium Hydro Engineering
Bild der Seite - 2096 -
Text der Seite - 2096 -
Fig. 2
Longitudinal section and details
In the exploratory tunnel and with investigations from the surface an intense
testing program has been performed in 2010 and 2011. Seven drillings with core
tests, water pressure tests and joint expansion tests have been conducted.
Additionally plate load tests, mineralogical analysis and rock mechanical laboratory
testing were executed to obtain uniaxial compressive strength, tensile splitting
strength, stress and deformation characteristics. The UCS has a range from 77 to
130N/mm², the tensile splitting strength ranges from 9 to 15N/mm² and the
deformation modulus is determined with 15 to 18GPa. For the FE predictions
presented in the following only one material set was classified, which is defined
with a linear elastic – perfectly plastic constitutive model using a Mohr-Coulomb
failure criterion.
4. FINITE ELEMENT ANALYSIS
4.1. PRELIMINARY 2D ANALYSIS
Because of the geological situation (see Fig. 2), it was expected that the
principal stresses in the initial state are not horizontal/vertical but rotated. To
determine the initial stress situation in the area of the powerhouse and the
transformer cavern two dimensional plane strain models were defined in Plaxis 2D
(Brinkgreve et al. [3]). A cross section ranging from the sea level of the Vermunt
reservoir up to the peak of the Kresper mountain was modelled. The location of the
cross section is shown in Fig. 1b.
2096
Book of Full Papers
Symposium Hydro Engineering
- Titel
- Book of Full Papers
- Untertitel
- Symposium Hydro Engineering
- Autor
- Gerald Zenz
- Verlag
- Verlag der Technischen Universität Graz
- Ort
- Graz
- Datum
- 2018
- Sprache
- englisch
- Lizenz
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Abmessungen
- 20.9 x 29.6 cm
- Seiten
- 2724
- Schlagwörter
- Hydro, Engineering, Climate Changes
- Kategorien
- International
- Naturwissenschaften Physik
- Technik