Seite - 2098 - in Book of Full Papers - Symposium Hydro Engineering
Bild der Seite - 2098 -
Text der Seite - 2098 -
Fig. 4
a) 3D FE model: powerhouse cavern, transformer cavern, side tunnels and gate
chambers, b) Calculation phase - excavation level E2 of powerhouse cavern
The maximum vertical displacements in the powerhouse cavern are in the
range of 15 to 20mm. Fig. 5a shows the contour lines of vertical displacements
after the final construction step. The maximum vertical displacements do not occur
at the center of the caverns due to the rotation of principal stresses at the initial
stress state. The analysis showed that the maximum deviatoric stresses occur in
the powerhouse at and slightly above the gate chambers. In addition, the relative
shear stresses (
rel), which represent the ratio between current shear stress and
maximum shear stress, the rock can sustain, indicate sensitive zones at and right
above the gate chambers. Fig. 5b represents the contour lines of deviatoric
stresses after the final construction phase. However, it has to be mentioned that
the anchors and the shotcrete lining are not modelled in this 3D finite element
analysis, and the results shown in Fig. 5b indicate that the depth of high shear
stresses is relatively small (which corresponds also to the evaluation of relative
shear stress). Thus, it can be concluded that this stress concentrations are well
covered by the anchors.
Fig. 5
a) Contour lines of vertical displacements, b) Contour lines of deviatoric stresses
2098
Book of Full Papers
Symposium Hydro Engineering
- Titel
- Book of Full Papers
- Untertitel
- Symposium Hydro Engineering
- Autor
- Gerald Zenz
- Verlag
- Verlag der Technischen Universität Graz
- Ort
- Graz
- Datum
- 2018
- Sprache
- englisch
- Lizenz
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Abmessungen
- 20.9 x 29.6 cm
- Seiten
- 2724
- Schlagwörter
- Hydro, Engineering, Climate Changes
- Kategorien
- International
- Naturwissenschaften Physik
- Technik