Seite - 2159 - in Book of Full Papers - Symposium Hydro Engineering
Bild der Seite - 2159 -
Text der Seite - 2159 -
In Fig.5 above, the active power is shown for the examined time region. It
can be seen that the power fluctuations of unit 1 are higher than those of unit 3.
Unit 2 shows nearly constant power output. The maximum power changes are
approximately 10 MW, which is approximately 20% of the output.
Assuming that by relations of output variation with head variation according
to hydraulic similarity;
N ∝ H ·Q = H^3/2 [1]
{N : Avtive power(MW), H : Head(m), Q : Discharge(CM/s)}
According to the above formula, 12% of pressure variation makes 17.4% of
power variation. Referring to Fig. 6 below, there are some gaps between
measured power variation (20%) and calculated power variation (17.4%).
The reason for the gap is the inaccuracy of the pressure data, which was
measured at a certain cross section having unsteady water flows due to the
vortices, so that the measured pressure is not representing the real pressure at
the certain cross section. Anyway, we can verify, there is a strong relation
between power variation and head variation.
It can be found that the power oscillations are caused by the pressure drop.
This pressure drop is caused by the unsteady vortices in the trifurcations. When a
vortex from the trifurcation enters one of the penstocks (left or right), the head
losses at the penstock inlet significantly increase because of the swirl
component. It could be observed from the measurement data that the dominant
reason for the power oscillations is the pressure drop in penstock and
consequently the reduction of pressure in the spiral case and turbine leading to
critical velocity of 4 m/sec (approx.). Therefore, it seems obvious that the
unsteady water flow, vortices in the trifurcation and the critical velocity of around
4 m/sec are causing the power oscillations and not the other factors such as the
governor or unsteady water flow through the draft tube and tailrace.
Fig. 6
Pressure at the spiral case inlet in the examined time region
2159
Book of Full Papers
Symposium Hydro Engineering
- Titel
- Book of Full Papers
- Untertitel
- Symposium Hydro Engineering
- Autor
- Gerald Zenz
- Verlag
- Verlag der Technischen Universität Graz
- Ort
- Graz
- Datum
- 2018
- Sprache
- englisch
- Lizenz
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Abmessungen
- 20.9 x 29.6 cm
- Seiten
- 2724
- Schlagwörter
- Hydro, Engineering, Climate Changes
- Kategorien
- International
- Naturwissenschaften Physik
- Technik