Seite - 2222 - in Book of Full Papers - Symposium Hydro Engineering
Bild der Seite - 2222 -
Text der Seite - 2222 -
Table 2: Basic requirements for different lining systems
Fig. 5 is showing a comparison of those lining types regarding construction
cost. As a basis, a design discharge has been chosen with 30m³/s. Considering
tunnel diameter optimizations, for the concrete or segmental lined types, a flow
velocity was anticipated with about v=3m/s; for the steel lined types the flow
velocity was anticipated with about v=6m/s.
Figure 5: Cost factor for different lining types considering lining costs
Requirements no lining
(invert only) unsealed
lining (USL) unsealed
lining +
borehole
grouting
(USL + BHG) pre-
stressed
lining
(PSL) plastic
membrane
sealed
lining
(PMSL) steel
membrane
sealed
lining
(SMSL) rock mass
supported
steel liner
(SRM) self bearing
steel liner
(SSB)
rockmechanical
requirements stable rock-
mass under
internal
pressure
fluctuation too;
non erodable
rock mass massive to
disintegrated,
non erodable
rock mass highly jointed
to
disintegrated
rock mass every kind of
rock mass;
minimal
principle
stress must be
known no relevant
requirements
hydrogeological
requirements external
watertable
above inner
pressure; or
watertight rock
mass external
watertable
above inner
pressure; or
watertight rock
mass (kf < 10 -7
m/s) external
watertable
preferable
above inner
pressure;
groutability with
cement grout
(kf >10 -5
m/s) external water
pressure must
be known;
groutability with
cement grout
(kf >10 -5
m/s) in
case of
consolidation
grouting external water
pressure must
be known
int. pressure
conditions
environmental
restrictions no relevant impact
no relevant requirements
slow dynamic pressure fluctuation (up- and
downsurge only)
expected water inflow in line with restrictions no relevant requirements; groutability
with cement grout (kf >10 -5
m/s) in case
of consolidation grouting
every kind of rock mass; minimal
principle stress above grouting
pressure
minimal principle stress emply above
dynamically internal pressure
0 1 2 4 5 11 21 28
-
5,00
10,00
15,00
20,00
25,00
30,00 Cost factor of different lining types
2222
Book of Full Papers
Symposium Hydro Engineering
- Titel
- Book of Full Papers
- Untertitel
- Symposium Hydro Engineering
- Autor
- Gerald Zenz
- Verlag
- Verlag der Technischen Universität Graz
- Ort
- Graz
- Datum
- 2018
- Sprache
- englisch
- Lizenz
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Abmessungen
- 20.9 x 29.6 cm
- Seiten
- 2724
- Schlagwörter
- Hydro, Engineering, Climate Changes
- Kategorien
- International
- Naturwissenschaften Physik
- Technik