Seite - 2230 - in Book of Full Papers - Symposium Hydro Engineering
Bild der Seite - 2230 -
Text der Seite - 2230 -
water velocity, negative pressure outside the structure when it is empty, way of
operating the structure, roughness of the subgrade, etc. The geomembrane liner
is anchored by mechanical fastening lines whose type, number and position is
designed based on the mentioned designed loads at full and empty tunnel, and
taking into account also the dynamic action of water that would result from a tear
in the geomembrane liner. Water velocities of several meters/second and
pressures of several MPa can be accommodated.
A drainage system is provided behind the geomembrane to collect and
discharge water that should be present behind the geomembrane liner, be it water
migrating from the slopes towards the structure, or already impregnating a
deteriorated concrete liner. The drainage system avoids that if the tunnel is
dewatered backpressure can build up and ultimately exceed the resistance to burst
of the geomembrane.
2.2. COMPONENTS
The liner adopted in all state-of-the-art projects is SIBELON® CNT, a
geocomposite consisting of a flexible polyvinylchloride geomembrane, heat-
bonded to an anti-puncture geotextile. The geomembrane, with hydraulic
conductivity k = 6.25 *10-14 cm/s, provides the water barrier, the geotextile protects
the geomembrane against puncturing from the substrate. The geocomposite
shows the tensile stiffness of the geotextile up to a strain > 60%, for larger stresses
the material presents the characteristic elastic behaviour of the geomembrane up
to a strain > 250%. The design strength of the geocomposite liner is assumed to
be the geotextile break tension, in the range of 50-60 kN/m, while the
geomembrane elasticity is activated only in case excessive stresses would
produce delamination of the backing geotextile. For design purpose, the strength
parameters of the geocomposite, are corrected to account for potential defects not
detected by the QC process, for incorrect installation, and for ageing of the
polymeric material.
The anchorage system consists of continuous stainless-steel anchorage
lines parallel to the water flow. These longitudinal fastening lines can be tensioning
profiles, or batten strips, designed/installed to avoid slack areas and folds in the
liner. The design of the anchorage lines is based on exceptional scenarios, aiming
at avoiding that extreme loads may cause the failure of the anchorage system with
the risk of detachment of metal elements and geocomposite fragments. The
calculations are based assuming that, in case of accidental damage resulting in
the perforation and/or cutting of the geocomposite liner, the water infiltrating
through the damage can generate a negative pressure behind the liner equal to
the internal pressure in the tunnel/ shaft. In this condition, remote but crucial for a
correct design, the kinetic head of the water flow can generate uplift and
deformation of the geocomposite liner. The tension in the geocomposite is
obtained by an equation based on the kinetic head (function of the water velocity
2230
Book of Full Papers
Symposium Hydro Engineering
- Titel
- Book of Full Papers
- Untertitel
- Symposium Hydro Engineering
- Autor
- Gerald Zenz
- Verlag
- Verlag der Technischen Universität Graz
- Ort
- Graz
- Datum
- 2018
- Sprache
- englisch
- Lizenz
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Abmessungen
- 20.9 x 29.6 cm
- Seiten
- 2724
- Schlagwörter
- Hydro, Engineering, Climate Changes
- Kategorien
- International
- Naturwissenschaften Physik
- Technik