Seite - 2236 - in Book of Full Papers - Symposium Hydro Engineering
Bild der Seite - 2236 -
Text der Seite - 2236 -
The upper shaft is about 71.5 m high and with internal diameter 4.1 m, the
surge shaft about 108.9 m high with an internal diameter of 2.5 m. The maximum
hydrostatic pressure in the surge chamber is about 0.6 MPa, in the surge shaft
about 1.74 MPa. The elevation of the water table is such that the bottom part of
the upper shaft and the rest of the structure are permanently below the water table,
with consequent presence of water in the rocky mass during the period of
emptying.
The selected waterproofing liner is the geocomposite SIBELON® CNT 4400
(3.0 mm thick geomembrane heat-bonded to a 500 g/m2 geotextile). Due to the
water pressure, a support geocomposite layer, consisting of a geogrid backed by
a nonwoven polypropylene geotextile, is placed under the SIBELON
geocomposite (“Fig. 5” at left). The geocomposite is fastened longitudinally by
stainless-steel batten strips, section 60 x 6 mm, anchored by mechanical anchors
selected in function of the strength of the concrete. The surge chamber has 10
fastening lines, the surge shaft has 8 fastening lines. Tensioning of the
geocomposite is achieved by an installation sequence of progressive closure,
placing the “First phase” anchorage lines and subsequently the “Second phase”
anchorage lines, which produces a tensioning effect on the geocomposite liner in
between two adjacent first phase anchorage lines. This method avoids formation
of slack areas and wrinkles in the geocomposite. Perimeter seals are the same as
for Belden.
Fig. 5
Tunjita surge shaft. Vertical view from bottom to top of the support geocomposite,
and of the waterproofing geocomposite fastened and tensioned
3.3. TUNJITA TUNNELS
The connection and pressure tunnels, have a length of about 142 meters and
a horseshoe section 3.60 m wide and with height varying up to 5.85 m. The
maximum hydrostatic pressure in the connection tunnel is about 1.90 MPa, and in
the pressure tunnel about 1.91 MPa, and 2.2 MPa at closing of the gates. The
maximum water velocity is 2.4 m/s.
2236
Book of Full Papers
Symposium Hydro Engineering
- Titel
- Book of Full Papers
- Untertitel
- Symposium Hydro Engineering
- Autor
- Gerald Zenz
- Verlag
- Verlag der Technischen Universität Graz
- Ort
- Graz
- Datum
- 2018
- Sprache
- englisch
- Lizenz
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Abmessungen
- 20.9 x 29.6 cm
- Seiten
- 2724
- Schlagwörter
- Hydro, Engineering, Climate Changes
- Kategorien
- International
- Naturwissenschaften Physik
- Technik