Seite - 2245 - in Book of Full Papers - Symposium Hydro Engineering
Bild der Seite - 2245 -
Text der Seite - 2245 -
Therefore the accuracy of the numerical model is confirmed and yields additional
confidence for the simulation results.
4.2. MAXIMUM SURGE TANK OSCILLATION
In order to achieve the allowable operating limits for the power plant with
increased power output, the maximum occurring surge tank oscillation must not
exceed the allowable limits in any possible operating mode. Therefore the
maximum and minimum liquid levels in the surge tank for a given gross head and
power output have to be identified.
The criterion for determining the maximum water level in the upper
reservoir (i.e. gross head) for a given power output is the maximum surge tank
oscillation (i.e. the maximum filling of the upper chamber). The maximum
allowable gross head is determined by following worst case scenario:
If all three turbines are put into operation from a standstill, the increasing
turbine flow rate will lead to a rapid decrease of the water level in the surge tank.
The nozzles are opened as far as possible for the given gross head, but the
maximum opening is limited with the maximum power output of the generator.
The system inertia of the headrace tunnel leads to an oscillation of the liquid level
in the surge tank. When the turbines are stopped in parallel at the same time
when the liquid level rises again, the surge tank oscillation can be forced to its
maximum amplitude.
The resulting maximum water level in the surge tank increases with
increasing gross head and turbine flow rate.
Fig. 4
Determination of maximum liquid level in the surge tank
The most critical time for stopping the turbines was found iteratively at 80
seconds after the start of the previous nozzle opening, by varying the closing
time. An example procedure is shown in Fig. 4 where the nozzle opening (s), the
liquid level
in the surge
tank shaft hs
nozzle
opening s
outlflow of upper reservoir QUR liquid level in
the upper
chamberhUC
80 s
2245
Book of Full Papers
Symposium Hydro Engineering
- Titel
- Book of Full Papers
- Untertitel
- Symposium Hydro Engineering
- Autor
- Gerald Zenz
- Verlag
- Verlag der Technischen Universität Graz
- Ort
- Graz
- Datum
- 2018
- Sprache
- englisch
- Lizenz
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Abmessungen
- 20.9 x 29.6 cm
- Seiten
- 2724
- Schlagwörter
- Hydro, Engineering, Climate Changes
- Kategorien
- International
- Naturwissenschaften Physik
- Technik