Page - 1717 - in Book of Full Papers - Symposium Hydro Engineering
Image of the Page - 1717 -
Text of the Page - 1717 -
1. INTRODUCTION
Rivers are continuously changing. This concept is understood by the people
who have settled near rivers for decades or engaged in agricultural activities
nearby. Their memories usually involve local motions and gradual or sudden
changes in rivers. One of the main sources of sediment is the bank erosion which
is significant in the development of floodplain and management of water
resources due to its influence on the characteristics of river channels. Bank
erosion also induces extensive damages to adjacent lands and buildings [1].
Investigation of channels around the United States of America indicated that bank
erosion is an important source of sediment load at most of the rivers [2]. However,
channel width is one of the most effective parameters for describing the
characteristics of natural channels and rivers as well as their morphology [3]. The
larger the river width, the higher the bank erosion rate would become. On the
other hand, bank erosion will result in the loss of adjacent fertile agricultural lands;
also, it will cause millions of dollars of damages each year [4]. Studies have
shown that riverbank sediments constitute about 30 to 80 percent of the total
sediment load of the watershed. These sediments are usually a result of the loss
of soil pore pressure as well as confining pressure during water surface lowering
after a rainfall [5]. Erosion due to seepage flow is one of the causes of river bank
erosion. In addition to entering a considerable amount of sediment directly into the
river, this type of erosion also causes internal erosion of the river’s surrounding
layers and mass failure of the upper layers. Important parameters contributing to
the formation of this erosion are listed below:
1- Flow exchange between the river and aquifers will loosen the surrounding
layer materials; hence, sediments are washed to the river by groundwater
flows from the aquifer.
2- Floods cause fluctuations in surface water level. When the water level rises,
some flows enter the surrounding layers, and when the peak flood is passed
the back waters from surrounding layers will cause internal erosion.
Many engineers believe seepage force causes the changes in soil particles
and decreases particle resistance against the erosive forces. Seepage force is
one of the reasons for internal erosion. When seepage flow has been seen in the
soil, not only it’s uplift force decreases the effective stress in the soil, but also
seepage force from the hydraulic gradient and consequently, the water velocity in
the soil is applied to the particles. Howard et.al. experimented the effect of
seepage on sand erosion. They showed that different hydraulic conductivities and
the river bank layering has been caused seepage forces and moving soil particles.
Internal erosion is a complicated factor of the river morphologic changes [6].
Hagerti did many of studies and field investigations that resulted in the existence
of a permeable layer between fine-graded and cohesive layers as being the main
reason for the internal erosion. This layer drains water and removes sediments
from the river bank and promotes internal erosion. Initiation of the internal erosion
depends on the hydraulic gradient. On the other hand, when the rainfall goes into
1717
Book of Full Papers
Symposium Hydro Engineering
- Title
- Book of Full Papers
- Subtitle
- Symposium Hydro Engineering
- Author
- Gerald Zenz
- Publisher
- Verlag der Technischen Universität Graz
- Location
- Graz
- Date
- 2018
- Language
- English
- License
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Size
- 20.9 x 29.6 cm
- Pages
- 2724
- Keywords
- Hydro, Engineering, Climate Changes
- Categories
- International
- Naturwissenschaften Physik
- Technik