Page - 1720 - in Book of Full Papers - Symposium Hydro Engineering
Image of the Page - 1720 -
Text of the Page - 1720 -
Then water enters the reservoir and penetrates into the sample. Based on
initial experiments the erosion in the sandy layer has been observed in heights
more than 15 cm; therefore, the water level in the reservoir was constant at first
(15cm), and it was added every 30 minutes by 2 cm to see and measure the
possible changes. When the water level was lower than the sandy layer bed, no
significant erosion was seen; while, when the water head was more than 15 cm it
caused a critical hydraulic gradient in the sandy layer. However, these values
were different for various gradations. The experiment continued until the surface
layer was cracked and collapsed.
Measured parameters during the tests included time, water level, output
discharge from the sandy layer, the weight of the removed sediments and the
depth of erosion. In every step, discharge was measured by using specified
volume containers at a specific time; since the maximum compaction was
considered in the other two layers and seepage was negligible; so, the measured
discharge was for the sandy layer. The sediments were collected and weighted by
using specified volume containers during the specific time. Also, erosion depth
was measured with a scaled ruler with a precision of mm.
2.2. DIMENSIONAL ANALYSIS AND DETERMINATION OF DIMENSIONLESS
PARAMETERS
The purpose of the dimensional analysis is to specify effective parameters
on the phenomenon under study and to determine the dimensionless relations.
There are a large number of parameters affecting these phenomena; so, it is not
possible to develop a specific mathematical relation for the analysis of the
problem. Therefore, dimensional analysis is used to present dimensionless
parameters. Effective parameters are as follows:
𝑓 (ℎ,𝑑
50,𝜌 ,𝜌
𝑠 ,𝑔 ,𝜇 ,𝑞
𝑠 ,𝐿 ,𝑑 ,𝜃 ,𝛼 ,𝑡 ,𝑡
𝑚 𝑎 𝑥 ) = 0 [1]
In the Buckingham π theorem, dimensionless groups (
) are selected, and
after some calculations, dimensionless relations are established based on the
obtained dimensionless groups. Some dimensionless ratios are also established
between some parameters.
𝑓 ( 𝜇
𝜌
𝑑 √𝑔
𝑑 , 𝑞
𝑠
√𝑔
𝑑 3 , 𝑑
𝐿 , 𝜌
𝜌
𝑠 , 𝑡
𝑡 𝑚
𝑎
𝑥 , ℎ
𝐿 ,𝜃 ,𝛼 ) = 0 [2]
The first one is Reynolds Number of the porous media. The critical Reynolds
Number states that the water flow between the particles changes from laminar
flow to turbulent flow has been shown in the range of 1 to 12. However, Reynolds
numbers would be considered equal to or less than one as a laminar flow [19].
The second one is sediment transport parameter, and sediment discharge is
1720
Book of Full Papers
Symposium Hydro Engineering
- Title
- Book of Full Papers
- Subtitle
- Symposium Hydro Engineering
- Author
- Gerald Zenz
- Publisher
- Verlag der Technischen Universität Graz
- Location
- Graz
- Date
- 2018
- Language
- English
- License
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Size
- 20.9 x 29.6 cm
- Pages
- 2724
- Keywords
- Hydro, Engineering, Climate Changes
- Categories
- International
- Naturwissenschaften Physik
- Technik