Page - 1754 - in Book of Full Papers - Symposium Hydro Engineering
Image of the Page - 1754 -
Text of the Page - 1754 -
layer and once the top Geotextile layer surface is placed over the Geomembrane, the top surface is
covered with a protective soil/rock layer.
The Geotextile layers are provided to protect the Geomembrane against physical damage as well as
to provide shear resistance which is critical on the slopes. Due to sensitivity of installation process,
extra care and quality control is required for the Geomembrane water tightening procedure.
The top protective layer is made of available alluvium material of higher one inch and with a
thickness of 15cm to 20cm with the use of manual non-vibration compactor. Main reason to use the
large size material in to avoid a fine-grain layer suitable for growth of plants during the operation
period while other benefits are listed below:
ď‚· protection against wrinkle effect of Geomembrane due to thermal expansion
ď‚· protection against uplift of Geomembrane during extreme wind under empty reservoir
condition
ď‚· protection against physical damage and act of vandalism
Assuming a 7m reservoir head and a permeability factor of 1Ă—10-12 cm/s for the 1.5mm thick
Geomembrane, the expected annual seepage from the Lake will be around 2000 m3.
3.6. Finding the Best Solution by Comparison between Water tightening Alternatives
Considering the above figures about the Lake, Water tightening option using the Clay Blanket was
eliminated and comparison between Geomembrane and Asphalt Concrete indicated that the
Geomembrane option is the most cost-effective solution for the Lake. Another distinctive advantage
of Geomembrane is the pace of installation which is much higher for the cold seasons compared to
the Asphalt Concrete. Furthermore, reliability of asphalt concrete is of concern as many
implemented hydraulic asphalt concrete did not fully meet the expectations for water tightening
performance. Ultimately the Geomembrane protection was selected as the preferred water tightening
option for the Chitgar Lake.
4. Geomembrane Installation and Quality Control
4.1. Implementation of Water tightening Layer on Chitgar Lake Bed
Water tightening layer for bed of the lake consists of a Geomembrane layer protected by two layers
of Geo textile on top and bottom as shown in Figure 5 covered with a protective coarse material
layer.
Figure 5. Preparation and Installation Stages for Water tightening of the Chitgar Lake bed
1754
Book of Full Papers
Symposium Hydro Engineering
- Title
- Book of Full Papers
- Subtitle
- Symposium Hydro Engineering
- Author
- Gerald Zenz
- Publisher
- Verlag der Technischen Universität Graz
- Location
- Graz
- Date
- 2018
- Language
- English
- License
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Size
- 20.9 x 29.6 cm
- Pages
- 2724
- Keywords
- Hydro, Engineering, Climate Changes
- Categories
- International
- Naturwissenschaften Physik
- Technik