Page - 1960 - in Book of Full Papers - Symposium Hydro Engineering
Image of the Page - 1960 -
Text of the Page - 1960 -
considerably increase the effect of grouting. The results will be clearer in
systematic grouting test panels and drilling of control boreholes. However, with
regard to the findings on these boreholes, dominant discontinuities are mainly
inclined in different directions in the plane, which indicate more success in contact
between the boreholes and joints, as clarified in joint surveys obtained from
investigation of surface discontinuities.
3. ASSESSMENT THE JOINTS STUDY OF WHITE LIMESTONE
After measuring discontinuities in the white-colored limestone (Lw) where the
LG1 tunnel has been excavated, it was found that the joint sets are a little different
from those selected based on the surface mapping. However, the dips are more or
less consistent and joints of 104/80 and 113/78 can be considered as one group
(50/83 with 63/84). Measurements were done in the 100-m long trench at the LG1
tunnel outlet portal, which is totally 84 joints. Stereographical image of the
discontinuities shown in figure 6 and 7 and their engineering geological features
have been provided in table 1.
Table 1
Discontinuities in white limestone surrounding gallery LG1. (SP = Spacing,
W1 = slightly weathered base on the IAEG suggestion)
Joint sets spatial Length (m) Spacing
(m) opening weathering
J1 063/84 1-3 20-40 2-10 W 1-3
J2 351/82 0.5-2 15-30 3-4 W 1-3
J3 113/78 3-6 10-40 1-5 W 1-3
J4 284/67 1-4 20-50 3-5 W 1-3
A distinct reality in the white limestone rock masses (Lw) is the formation of
slickenside along some joints, which is very crushed and erodible (photos 1 and 2)
and the rock mass is highly crushed and full of joints and cracks.
In underground investigations of the boreholes drilled at the left abutment of
Glevard dam site [phase I exploratory-grouting boreholes (LG01-EP) and
exploratory boreholes (BH02,3,4)] and joints and fissures of 60 to 90 degrees, a
large number of joint and fissures have been identified. The summary of the results
provided for white and gray limestone in table 2. In upper white limestone which
have more joints and fissures, crushing and water seepage, the frequency of joints
and fissures in different zones are as follows:
Zone 1: Includes boreholes EP1 to EP4 in the inclined curtain. 272 out of 780
discontinuities (34.8%) have angles of 30 to 60 degrees and most of them have
had angles of 80 to 90 degrees. In the inclined plane, these angles identified and
assessed as 15°.
1960
Book of Full Papers
Symposium Hydro Engineering
- Title
- Book of Full Papers
- Subtitle
- Symposium Hydro Engineering
- Author
- Gerald Zenz
- Publisher
- Verlag der Technischen Universität Graz
- Location
- Graz
- Date
- 2018
- Language
- English
- License
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Size
- 20.9 x 29.6 cm
- Pages
- 2724
- Keywords
- Hydro, Engineering, Climate Changes
- Categories
- International
- Naturwissenschaften Physik
- Technik