Page - 1975 - in Book of Full Papers - Symposium Hydro Engineering
Image of the Page - 1975 -
Text of the Page - 1975 -
1. More suitability of inclined boreholes compared to the vertical ones in each
vertical surface including the joint sets discussed here. This is a very clear
understanding and is certainly known by an expert, however, three directions have
been selected here to show it; 7° (access tunnel direction) which will be at the
same direction with the grout curtain, too, 140° (azimuth of the grout gallery) and
50° (azimuth of the grout gallery).
2. To do this, joint sets in table 1 (based on the 84 measured joints) have
been delineated in 1 m2 of the vertical surface, so that the maximum number of
joints can be shown. The spacing (SP) of these joints is available which will be as
Sph = SP/sin a on a horizontal line along the dip direction of the joint [5]. Figure17
shows the vertical boreholes in all the three vertical surfaces with the mentioned
directions. It can be clearly seen that at the contact point of the borehole with the
joints at 140° direction surface, it is more than the other two directions; 5 against
4.
7° is the direction of the access tunnel and grout curtain. It clearly concluded
that there are clear advantages in 50 and 140 degrees directions compared with
7-degree direction, in the vertical curtain. The opening of the joints in three
directions have been estimated using the following relationship and β is the
gradient between d’ and δ[6].
Sph𝛽 = 𝑠 𝑝 . 𝑐
𝑜 𝑡
𝑔
𝛼
′
𝑐
𝑜
𝑠 𝛼
α’ = 𝑡
𝑔 − 1 (𝑐
𝑜 𝑠 𝛽 .𝑡
𝑔
𝛼 )
The number of boreholes to be drilled in this 1 m2 with the most contact
points, in the 50° direction surface is 3 boreholes and in the other two directions is
2. View of the joints contacts clearly shows more and wider open spaces in the 7°
direction. Generally, advantages of the 50 and 140 degrees directions seen from
the 7° direction.
This view shown in figure 10 for the inclined boreholes in all the mentioned
three vertical surfaces where advantages of inclined boreholes compared to the
vertical ones in 50 and 140 degrees direction are quite clear.
3. If we look at the inclined curtain with 097/75 spatial layout, if the same
features of the joints existing in vertical surfaces turn by the value of the 0 slope,
the difference in the sooner contact of the inclined boreholes with the joints will be
clearly recognized. It is impossible to drill a vertical borehole in such an inclined
surface. However, the view of the four joints and cross of the boreholes shown with
the following relationships
4. All of the observed discontinuities at the ground surface and walls of the
river and the excavated trenches, mainly express figures whose geometrical forms
and surface forms of the discontinuities shown on figure 18.
1975
Book of Full Papers
Symposium Hydro Engineering
- Title
- Book of Full Papers
- Subtitle
- Symposium Hydro Engineering
- Author
- Gerald Zenz
- Publisher
- Verlag der Technischen Universität Graz
- Location
- Graz
- Date
- 2018
- Language
- English
- License
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Size
- 20.9 x 29.6 cm
- Pages
- 2724
- Keywords
- Hydro, Engineering, Climate Changes
- Categories
- International
- Naturwissenschaften Physik
- Technik