Page - 2124 - in Book of Full Papers - Symposium Hydro Engineering
Image of the Page - 2124 -
Text of the Page - 2124 -
stress ratios, a presumed value of 0.25 seemed to be a conservative and thus
acceptable assumption for the prediction of the k0 ratio. In tunnel portions, where
existing stresses do not satisfy the confinement criterion, a watertight tunnel lining
has to be provided.
Fig. 7
Comparison of hydrostatic water
pressure with the minimum shut-in
pressures within the 2000 m of the
inclined pressure tunnel close to the
power cavern Comparaison de la pression de l'eau
hydrostatique avec les pressions de
fermeture minimales dans les 2000 m
du tunnel à pression inclinée près de la
caverne de puissance.
Figure 7 compiles the minimum shut-in pressures obtained from the hydro-
fracturing test campaigns, carried out approximately every 250 metres, starting
from the Powerhouse Cavern. By comparison with the hydrostatic water pressures
inside the tunnel during operation, the safety factor against hydro-fracturing was
determined, resulting in values below 1.0 over large portions of the tunnel length.
In order to meet the confinement criteria a watertight element was required along
the first 2.0 kilometers from the power cavern, and it had been decided to install a
steel lining within this reach, with steel plate thicknesses of up to 34 mm.
In combination with low horizontal and vertical overburden, the presence of
the Cordillera Blanca fault zone negatively influences the stress pattern, which was
determined during tunnel excavation by several hydro-fracturing tests, showing
significantly reduced horizontal stresses, with k0-values within 0.2 to 0.3, which is
unusually low for a young mountain range.
The diagram Figure 8 indicates the topography (brown line), the elevation of
the tunnel axis (blue line), the required level of safety according to EM-1110-2-
2901 (yellow line) and shows the achieved safety factors (red and green dots) for
a minimum stress ratio of k0 = 0.25 in the tunnel section upstream of the steel lining.
2124
Book of Full Papers
Symposium Hydro Engineering
- Title
- Book of Full Papers
- Subtitle
- Symposium Hydro Engineering
- Author
- Gerald Zenz
- Publisher
- Verlag der Technischen Universität Graz
- Location
- Graz
- Date
- 2018
- Language
- English
- License
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Size
- 20.9 x 29.6 cm
- Pages
- 2724
- Keywords
- Hydro, Engineering, Climate Changes
- Categories
- International
- Naturwissenschaften Physik
- Technik