Page - 2175 - in Book of Full Papers - Symposium Hydro Engineering
Image of the Page - 2175 -
Text of the Page - 2175 -
Figure 4.6 Installation Lifting Table Component
Working tools for HCV lift overhaul using balanced cantilever. The tool
was designed by LAPI ITB then tested on September 8th, 2015 at PT. Barata Tegal
and test site on February 20th, 2017 with conclusion that this tool can lifting and
lowering HCV.
The next step is preparation path road for vehicles and destruction heavy
equipment at dock/port. Preparation that has been done by adding sirtu (sand
stone) on the entrance to dock (entrance portal) and dredging of pontoon area for
pulled over and stone pile addition in heavy equipment position (car crane) which
lifting HCV.
4.2.2. Unloading
Process of diasassemble old HCV begins with release 84 pieces flange bolt
then right and left arm drive bolts, then the trolly is positioned just below the
HCV and tied with the trolly by using the sling.
The detached HCV and above trolley move out just below the lifting table
and lifting column.
Lifting process the old HCV from trolley upwards using a 20 ton chain
block of 2 pieces which located at lifting column, was manually lifted with human
power.
Balanced cantilever is prepared for lifting old HCV by lowering binding
hook on hoist and tied to old HCV. Lifting process approximately 2 hours get to
morning glory side because lifting equipment speed is made at low speed to HCV
that weighs nearly 35 tons in process of lifting is not rocking.
After old HCV on morning glory side and shifts to outside then the
pontoon that has been prepared with holder/saddle near to morning glory just
2175
Book of Full Papers
Symposium Hydro Engineering
- Title
- Book of Full Papers
- Subtitle
- Symposium Hydro Engineering
- Author
- Gerald Zenz
- Publisher
- Verlag der Technischen Universität Graz
- Location
- Graz
- Date
- 2018
- Language
- English
- License
- CC BY-NC-ND 4.0
- ISBN
- 978-3-85125-620-8
- Size
- 20.9 x 29.6 cm
- Pages
- 2724
- Keywords
- Hydro, Engineering, Climate Changes
- Categories
- International
- Naturwissenschaften Physik
- Technik